BLUE GREEN · CURATED PAINT RECIPE
How to mix turquoise paint
A bright, light blue-green for water, jewelry, decorative accents, and tropical palettes.
STARTING MIX
5 : 1 : 0.5 : 0.25
Use one consistent unit for every part. For the smallest fractions, scale the entire recipe up instead of estimating a partial drop.
Useful first test, with the claim kept honest
This recipe uses pigment behavior and color relationships to define a controlled starting point. It is not yet a named, brand-calibrated studio test. The target is an sRGB reference; your dried paint remains the deciding evidence.
PIGMENT LOGIC
Why this mixture works
Turquoise is easier to control by tinting white than by lightening a dark teal. The blue remains dominant while green and yellow establish the characteristic tropical bias.
The displayed #44B7B1 swatch is an sRGB target, not a promise that every brand will dry to the same color. Pigment identity, tint strength, opacity, medium, surface, and lighting remain part of the result.
BASIC-PALETTE ROUTE
Alternative recipe
Start from white, tint with a cyan blue, then add green in half the amount. A tiny yellow addition keeps the result from feeling icy.
Apply the mixture on the same ground and at the same thickness planned for the final work. Label the wet ratio, wait for a complete dry-down, and compare in neutral light before adjusting.
CORRECTION MAP
How to adjust the result
More blue creates aqua, more green creates jade, and more white creates a pastel. If it feels synthetic, mute it with a trace of burnt sienna.
Correct value first, then hue, then chroma. This order prevents a lightness error from turning into an unnecessarily complicated recipe.
WATCH FOR
Common mistakes
- Using ultramarine as the only blue
- Combining equal blue and green
- Adding black to darken a bright turquoise
SCALE THE BATCH
Keep fractional parts measurable
Choose a scale that turns the smallest addition into a unit you can repeat. The proportions stay identical.
MEDIUM CHECKS
Translate the ratio into your material
- Acrylic: compare only after full dry-down and keep film thickness consistent.
- Oil: inspect both the thick mass tone and a thin application; transparent pigments can shift strongly with thickness.
- Watercolor: mix by repeatable brush loads or drops, record dilution, and use the intended paper.
- Miniature paint: match the primer, thinning, wash, and final varnish used on the model.
VERIFICATION PROTOCOL
What to record with the swatch
- Exact brand, range, color name, and pigment code where available.
- One measurement unit and the full ratio before any correction.
- Medium, surface, ground or primer, and application thickness.
- Wet observation, fully dry observation, light source, and date.
- The largest remaining value, hue, or chroma error and one next adjustment.
THREE USEFUL VARIATIONS
Extend one successful base
- Lighter: split off a sample and raise value gradually; inspect whether white also cools or dulls it.
- Darker: use a related chromatic dark before reaching for black, then compare the undertone.
- Quieter: reduce chroma with a prepared near-complement in very small steps so the value does not collapse.